Type: Driver
File Name:
File Size: 30.7 MB
6 (4.1)
Downloads: 2
Supported systems: Windows 2008, Windows XP, Windows Vista, Windows 7/8/10
Price: Free* (*Free Registration Required)

Download Now

AR-M/AR-EB9 Scanner driver free download for windows - GBT___ - AWRDACPI

Bookmarks Bookmarks Digg del. Get the Android App. Save for Later Add to Compare. If the distance is not within the specified ar-m165 scanner, loosen the fixing screw A of the main pole ar-m165 scanner plate, and move the adjustment plate in the arrow direction to adjust. Perform the same procedure for front and the rear frames.

ar-m165 scanner If it is within specified range, then fix the doctor fixing screw with screw lock. Developing doctor gap Both ends 20mm from the both ends : 1.

Mechanism section 1 Image position adjustment a. Ar-m165 scanner image lead edge position adjustment SIM Note: In advance to this adjustment, the sub scanning magnification ratio adjustment must be performed. If necessary, perform the following adjustment procedures.

1 copier/scanner/printer SHARP AR-M165, with di...

Select a desired mode with the arrow keys, enter the adjustment value with key, and press [OK] key. The voltage is outputted ar-m165 scanner the grid bias High output mode during warming up, and in the grid bias Low output mode when warming up is ar-m165 scanner.


The print start ar-m165 scanner is shifted inside the document edge. Calculate the set value from the formula below. Enter the set value of the image scanning lead edge position RRC-A again. When setting the lead edge void to 2.


Set the image print start position set value TRAY1 again. Compare the copy and the test chart. If necessary, perform the following adjustment procedure. After completion of warm-up, shading is performed and the currently set off center adjustment value ar-m165 scanner each paper feed port is displayed.

Sim PRT. The correction value is stored and a copy is made. Void amount Standard value: ar-m165 scanner or less. Note: Before performing this adjustment, be sure to check that the paper off center adjustment SIM is completed. The ar-m165 scanner set adjustment value is displayed.

The correction value is stored. At that time, if the front frame side and the rear frame side of No. If one of them is in contact with the ar-m165 scanner plate, perform the adjustment of 4. When the lamp unit, or No. When a copy as shown is made. ar-m165 scanner

Do not move the mirror base drive pulley shaft. Glass holding plate A3 11" x 17" white paper Fit the paper edge and the glass holding plate edge. Paper exit direction La: Lead edge black background width Lb: Rear edge black background width If the width La of the black background at the lead edge is equal that Lb at the rear edge, there is no need to execute the following procedures of 4 - 7. The correction values are saved and a copy is made. Note: Since the printed copy is used as a test chart, put ar-m165 scanner scale in parallel with the edge lines. The set value is stored and a copy is made. SCAN] mode with the cross cursor. Original guide. Before performing this adjustment, the OC mode adjustment in copying must be completed.

Sim ORG. Specifications Center 2. When the display is Check that the SPF is open.


Check that the lamp is ON.This page contains the driver installation download for AR-M/AR-EB9 Scanner in supported models (AWRDACPI) that are running a supported ar-m165 scanner. copying/printing, brilliant colour scanning, optional Super G3 faxing, as well And with options available for powerful network printing/scanning, the AR-M

Other Drivers